Data retrieval to CAPS using SeedLink plugins. Path to buffer file where transient packets are stored on disk during shutdown. Transient means packets that have been received from input plugins, e.g., chain_plugin but have not been acknowledged by CAPS. Without local storage on disk those packets would be lost. During start the plugin reads the buffer file and tries to send the packets again. Please keep in mind to remove the buffer file before plugin start in case of the data acquisition should be reset. Data input control Path to Seedlink configuration file. Use the respective name if seedlink runs as an alias. Name of Seedlink configuration section. Use the respective name if seedlink runs as an alias. Data output control Write miniSEED records to stdout instead of pushing them to CAPS. Data output URL [[caps|capss]://][user:pass@]host[:port]. This parameter superseds the host and port parameter of previous versions and takes precedence. Data output host. Deprecated: Use output.address instead. Data output port. Deprecated: Use output.address instead. Timeout when sending a packet. If the timeout expires the connection will be closed and re-established. Maximum allowed relative end time for packets. If the packet end time is greater than the current time plus this value, the packet will be discarded. By default this value is set to 120 seconds. Size (bytes) of the packet buffer Length of backfilling buffer. Whenever a gap is detected, records will be held in a buffer and not sent out. Records are flushed from front to back if the buffer size is exceeded. File to store stream states Flush stream states to disk every n seconds Wait when a sync has been forced, up to n seconds Wait on shutdown to receive acknownledgement messages, up to n seconds Log information status information e.g. max bytes buffered Flush status every n seconds to disk generic#help generic#version generic#config-file generic#plugins generic#daemon Path to Seedlink configuration file. Default: @ROOTDIR@/var/lib/seedlink/seedlink.ini Name of Seedlink configuration section. Default: seedlink. verbosity#verbosity verbosity#v verbosity#quiet verbosity#print-component verbosity#print-context verbosity#component verbosity#syslog verbosity#lockfile verbosity#console verbosity#debug verbosity#trace verbosity#log-file Data output host. Default: localhost. Data output port. Default: 18003. Write records to stdout. Maximum allowed relative end time for packets. If the packet end time is greater than the current time plus this value, the packet will be discarded. By default this value is set to 120 seconds.